Tenda O8 5GHz 11ac 23dBi Gigabit Outdoor CPE
- 20km Transmission Range
- 5GHz 11ac 433Mbps
- IP65 Rated
The Tenda O8 is a point to point CPE that can be used as either a 20km signal extender or as a WISP to source and share signal from a WiFi hotspot (Read more)
The Tenda 08 5GHz is a Gigabit outdoor CPE designed to provide PP2 (Point to Point) and PtMP (Point to Multi-Point) solutions for private ISP wireless connectivity, CCTV surveillance and data transmission. It uses a 23dBi directional dual polarisation antenna to provide an efficient way to pick up and maintain a stable long-distance connection with a range of up to 20km. Two CPEs can also connect easily with one another automatically using auto-bridging technology which makes setup a breeze.
20km+ Transmission Range
The Tenda O8 features a 23dBi directional antenna to receive and maintain a stable signal for the wireless network. By using auto bridging technology, 2 CPE devices will connect to each other automatically to make set up quicker and easier.
6000V Surge Protection Design
Due to their very nature, CPE devices tend to be installed outside and in elevated positions, which increases the chance of lightning strikes that can cause irreparable surge damage to electronic equipment. The Tenda O8 features 6000V ethernet port Surge protection which protects the network against such strikes.
Easy to Assemble and Install
The Tenda O8 three-axis alignment makes it is easy to assemble in seconds. Only a single screw driver is required for pole-mounting.
The Tenda O8 features 24V0.5A passive PoE (Power over Ethernet) which enables both power and data to be sent over a single cable, making installation quicker, easier and more cost effective.
A PoE LED indictor light allows you to see the status of the PoE at a glance which speeds up installation.
TD-MAX-Tenda TDMA proprietary protocol
TD-MAX is Tenda TDMA (Time Division Multiple Access) proprietary protocol to improve performance and capacity for wireless WISP outdoor application scenarios. In the outdoor environment, the CPE uses highly directional antennas to connect to the Basestation from distances that can span several kilometers. the CPE can't sense each other, they become “hidden nodes” and cannot coordinate access to the wireless channel. Thus, the Basestation experiences frequent collisions from stations transmitting simultaneously. As the network scales, these collisions build up exponentially, increasing latency and lowering throughput. With TD-MAX, it coordinates all the data transmission and allocates time to active clients to provide greater noise immunity performance when compared to the conventional 802.11 CSMA/CA (Carrier Sense Multiple Access / Collision Avoidance) protocol.
Channel Shift to Avoid Interference
The O8 provides Channel Shift feature to offset the central frequency 5MHz upper. It can avoid interference from nearby AP and deliver higher throughput.
CPE Assistant-Centralised Management Platform
The O8 is equipped with centralized management software that helps users easily manage all the devices in their network from a single PC - CPE Assistant. Functions like device discovery, status monitoring, firmware upgrading, and network maintenance can be managed using CPE Assistant.
Multiple Application Scenarios
As well as a long-distance wireless connection device, the Tenda O8 can also be used in WISP mode to wirelessly connect to WISP hotspots to share internet to local wired & wireless networks.
- 5GHz 11ac 433Mbps
- One Gigabit ethernet port
- 23dbi dual polarization antenna
- IP65 weatherproof enclosure
- 6000V Lightning Protection
- AP, Station, WISP operating mode supported
- Up to 60 metres of flexible deployment with included PoE adapter
|PtP and PtMP wireless connection for Private
ISP access or CCTV Surveillance
|Maximum Wireless Rate
|1*10/100/1000Mbps Ethernet Port
|Horizontal: 10° Vertical: 10°
|PoE/LAN, LED1, LED2, LED3
|24V 0.1A Passive PoE
|Passive power over ethenet via PoE/LAN(✚4,5pins,-7,8pins
Voltage range: 9-35V DC
|11a 6Mbps -96dBm±1.5dBm
11n MCS7 HT20 -72dBm±1.5dBm
11ac MCS9 HT80 -65dBm±1.5dBm
|Enable/Disable Wireless Radio
|Wireless Client Isolation
|Wireless Access Control
|Weak Signal Client Limitation
|Adjustable power by 1dBm
|VLAN Tagging for SSID
|Remote Web access
|Ping, Traceroute, Signal Scan
|Time & Date Setting
|Managed By Controller
|PC Software-CPE Assistant
|1*5GHz 11ac 23dBi Gigabit Outdoor CPE O8
1* Power Adapter
1*Quick Installation Guide
|-30℃ ~ 60℃
|-40℃ ~ 70℃
|Default login IP
|Default Login Username
|Default Login Password
|-- No videos available --
|Tenda O8 Datasheet
|Tenda O8 Installation Guide
|Tenda O8 User Manual
|Tenda support site
Be the first to ask a question and help others interested in this product
Your feedback helps us improve our products and services as well as helping other users make informed buying decisions.
There are no reviews for this product.
Why buy from Connectec?
Our technical support team are experienced installation engineers with years of field experience.
Customer service is our top priority. We always try to ensure we offer a first class service too all our customers.
We offer FREE mainland UK delivery on orders over £75 and FREE next day delivery on orders over £150*.
* Qualifying products only, subject to terms. For more information view our delivery information.